Specifications

Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
TM-P60
Specification
(STANDARD)
E
11 10
1.19 Impact Resistance
1) Drop test when unpacked
Height: 120 cm {3.94’}
Type of floor: Concrete
Directions: 6 surfaces, 6 edges, and 2 corners
Times dropped: One time for each direction
EPSON has confirmed that no external or internal damage should be found after the drop test
when the printer is not printing.
2) Drop test when packed
Package type: Epson standard packing
Height: 60 cm {1.97’}
Directions: 1 corner, 3 edges, and 6 surfaces
EPSON has confirmed that the unit should operate normally after the drop test.
1.20 Battery Charging
1) Environmental conditions
0 to 40°C {32 to 104°F}
2) Charging method and period
The battery can be charged by the printer itself or the rapid battery charger OT-CH60 (option).
(1) Charging by the printer itself
The battery is charged through the battery charging circuit inside the printer when the AC
adaptor PS-10 is connected to the printer.
The battery is charged only when the printer’s power is off.
Charging period: Approximately 4 hours (new battery, room temperature)
Charging period is the period that becomes charged fully from the level L of the battery
remaining state.
(2) Charging by the rapid battery charger
The battery is charged by the rapid battery charger OT-CH60 (option) when the battery is
inserted into this battery charger.
Charging period: Approximately 2.5 hours (new battery, room temperature)
Charging period is the period that becomes charged fully from the level L of the battery
remaining state.
1.21 Acoustic Noise
Operating: Approximately 53 dB (ANSI bystander position)
NOTE: The value as shown above is measured when the EPSON evaluation printing pattern is
used. This value may be different, depending on the paper to be printed, the print duty, or
the print conditions, such as the print speed or the print density.
G