Instruction manual

Rev. A Disassembly, Assembly, and Adjustment 5-19

TM-T88 series Technical Manual

CAUTION:

You must follow the steps described below. If you do not follow them it could cause an

auto cutter operation failure.

1. Secure the right side screw.

2. Secure the left side screw.

3. Loosen the screw securing {cover-paper cutter assembly} once; then secure it again.

Note:

While securing these screws, do not deform {frame assembly}. This can damage the cutter.

N.E. detector assembly block

1. Detach the {lead wire-N.E. detector} from [N.E. detector assembly block].

2. Remove the single {RE 1.5} retaining ring.

3. Remove {screw-detector adjustment} and {hexagon nut M3}.

To remove these parts, rotate {screw-detector adjustment} counterclockwise.