Specifications

Chapter 1 Product Overview

PAPER OUT LED

•Lights when there is no more roll paper. When you select to use the thermal roll paper by DIP

switches, this LED lights also when there is little paper remaining.

•Off when there is a sufficient amount of roll paper remaining.

•Flashes when a self-test is in progress.

FEED button

Pressing this button once feeds the roll paper by one line. Holding this button down feeds the

roll paper continuously.

Connectors

All cables are connected to the connector panel on the lower rear of the printer.

• Drawer kick-out connector: Connects the cash drawer.

•Power supply connector: Connects the power supply unit

•Interface connector: Connects the printer with the host computer interface.

Offline

The printer automatically goes offline under the following conditions:

•During power on (including resetting with the interface) until the printer is ready

•During the self-test

•While roll paper is fed using the FEED button.

•When the printer stops printing due to a paper-end (if an empt

y paper supply is detected by

the roll paper end sensor or if the driver has been set to stop printing when a roll paper near-

end is detected)

•When an error has occurred

The picture above shows a serial interface model. For details on the various interfaces and

how to connect the power supply connector and cash drawer, see "Connecting the Printer

to the Host Computer" on page 46 and "Connecting the Cash Drawer" on page 55.

DC24V

Interface connector

Drawer kick-out connector

Power supply connector