Specifications

Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEET NEXT
D
TM-U230 series
Specification
(STANDARD)
App.5 App.4
4) Manual operation of the autocutter
In a paper jam, the printer may be stopped with the autocutter blade not in its normal position. In
such cases, insert the screwdriver into the hole at the right side of the autocutter, as shown in
Figure A-3, and turn the gear inside the cutter unit to move the cutter blade to its normal position.
Figure A-3 Autocutter
5) Fine coating (only for model with coating)
5)-1 Cautions on handling fine coating of the case
This printer is housed in a plastic case (*) with a fine coating; simple cleaning is enough to remove
dirt easily so that the exterior of the printer remains in good condition. Like other plastic cases,
handle the fine coating with care as described below.
(*) The fine coating is not applied to the installation surface of the metal plate and the inside of the
case.
[Caution]
• Do not scratch the surface with hard objects; otherwise the case may become damaged and dirt
may become difficult to remove.
• Do not use any type of abrasive agent (scouring powders, scouring pads, etc.) to clean the case;
otherwise the surface of the case may become damaged and dirt may become difficult to remove.
• Never clean the case with disinfectant, bleach, alcohol, benzene, thinner, chlorine, or ketone;
otherwise the dirt may become difficult to remove. Also, they may cause the case to discolor,
dissolve, or deform.
• The label may come off the fine coating of the case.