User`s manual

Setting Up the Printer 1-3
Store the protective material with the other packing materials and
use it when transporting your printer.
Connecting the Printer to Your Computer
Follow the procedures below only when you use the printer as a
single unit (not connected to an intelligent module). When you use
the printer with the intelligent module, see the IM-403/405 User's
Guide for details.
You need an appropriate interface cable to connect your computer
to the printer's built-in interface.
1. Make sure that both the printer and computer are turned off;
then attach the cable connector securely into the printer's
interface connector.
2. Tighten the screws on both sides of the cable connector.
Note:
Your printer comes with inch-type hexagonal lock screws
installed. To use an interface cable that requires millimeter-type
screws, replace the inch-type screws with the enclosed
millimeter-type screws using a hex screwdriver (5 mm). To
distinguish the two types of screws, see the figure below. The
inch-type screw is on the left.
U925_eng.book Page 3 Thursday, July 25, 2002 9:15 AM