User`s manual

Setting Up the Printer 1-5
Note:
To remove the cable connector, squeeze the connector's clip and pull
it out.
Connecting to a Direct Connection Display Module
If you are using the printer as a single unit (not connected to an
intelligent module) and you plan to connect a direct connection
display module, follow the steps below. When you use the printer
with the intelligent module, see the IM-403/405 User's Guide for
details.
1. Make sure that the printer is turned off.
2. Plug the cable connector (provided with the direct connection
display module) securely into the printer's display module
connector until it clicks.
CAUTION:
Do not connect this cable to the drawer kick out connector,
which is on the other side of the interface connector.
Also do not connect a telephone line to the display module
connector.
U925_eng.book Page 5 Thursday, July 25, 2002 9:15 AM