User`s manual

Setting Up the Printer 1-17
2. Determine the point on the paper roll at which you want the
paper roll end detection to be triggered. Then measure the
distance A shown in the illustration.
Note:
There may be some difference between the measured distance A and
the actual sensing position.
3. Find the corresponding adjustment position number from the
table below.
Distance A Adjustment position number
10 mm (0.39 inch) #1
8 mm (0.32 inch) #2
6 mm (0.24 inch) #3
4 mm (0.16 inch) #4
2 mm (0.08 inch) #5
distance A
U925_eng.book Page 17 Thursday, July 25, 2002 9:15 AM