User`s manual

1-18 Setting Up the Printer
4. Locate the adjusting screw and the positioning plate shown in
the illustration below.
5. Loosen the adjusting screw with a coin or a screwdriver.Move
the positioning plate to the appropriate position and then
tighten the adjusting screw, as shown below. Position 1 leaves
the least paper on the roll, and position 5 leaves the most
6. Be sure that the detecting lever moves freely after you finish the
adjustment.
7. Re-install the paper roll, as described earlier in this chapter.
#5
#4
#3
#2
#1
Loosen
Secure
U925_eng.book Page 18 Thursday, July 25, 2002 9:15 AM