User`s manual

2-6 Using the Printer
CAUTION:
Do not insert checks with staples in them. This may cause
paper jams, MICR reading errors, and damage to the MICR
head.
Be sure that the checks are flat, without curls, folds, or
wrinkles.
1. Wait until the computer sends the FS a 0 command to the
printer, causing it to enter the MICR mode. The SLIP light
blinks.
2. Turn the check over so that it is face down with the MICR
characters on the righthand side, as shown in the illustration
below. The MICR characters must be next to the right edge of
the paper inlet.
3. Insert the check straight into the paper inlet, using the right
edge of the paper inlet as a guide.
MICR characters must be on the underside
of this edge of the check
U925_eng.book Page 6 Thursday, July 25, 2002 9:15 AM