User`s manual

Reference Information 4-1

Chapter 4

Reference Information

Printing Specifications

Note:

*1 The printer automatically goes to low speed mode during bit image printing,

regardless of the type of selected paper.

*2 Print mode can be changed using the GS E command.

Printing method: Serial impact dot matrix

Head wire

configuration:

9-pin vertical line, 0.353 mm {1/72”}

wire pitch

Head wire diameter: 0.29 mm {.01"}

Printing direction: Bidirectional, minimum distance

printing

Printing speed: See table on page 4-2.

Characters per line: See table on page 4-2.

Characters per inch: See table on page 4-2.

Print modes: See the print modes table below.

Print modes

mode

Printing

speed*1

Print head

energizing

time

Paper roll Slip paper

Default

status

Switching*2

Default

status

Switching*2

Normal High Normal

Depends

on DIP

SW 2-4

Possible -- Possible

Low

speed

Low Normal Possible -- Possible

Copy Low Copy (long) -- Possible Selected Possible

U925_eng.book Page 1 Thursday, July 25, 2002 9:15 AM