User`s manual
Reference Information 4-5
Notes on MICR use
❏
Personal checks are fed in the forward direction only.
❏
The paper roll must be loaded correctly before selecting MICR
function. Otherwise, check paper is not fed properly.
❏
The check waiting state is canceled using DLE ENQ 3.
❏ After a personal check is ejected, the SLIP light comes on and
the printer does not proceed to the next operation until the
check is removed.
❏
The check waiting time and the interval from when a check is
inserted to when the operation starts can be set using ESC f.
❏
To check the MICR function status exactly, use DLE EOT BS 1.
❏
Remove ejected personal checks by pulling them upward. Do
not pull them out in the horizontal direction.
Paper Specifications
Paper feed method: Friction feed
Paper feed pitch: Default 4.23 mm {1/6 inch}
Can be set in units of 0.353 mm {1/144
inch} by the ESC 3 and ESC J
commands.
Paper feed speed: Approx. 60.3 ms/line (4.23 mm {1/6
inch} feeding)
Approx. 86.36 mm/second {3.4
inches/second} (continuous feeding)
Paper size: Paper roll (single-ply)
U925_eng.book Page 5 Thursday, July 25, 2002 9:15 AM