User`s manual

4-10 Reference Information
❏
Since the slip ejection detector uses a reflective photo detector,
paper that has holes or dark portions with low reflection (less
than 40% reflection) at the detector position must not be used.
(See the illustration below.)
❏
Be sure to perform slip printing with a paper roll loaded to
avoid paper jams.
❏
Use thinner paper (N30 or equivalent) between the top and
bottom sheets of multi-ply paper. If thick paper is used, the
copy capability is lowered
Electrical Characteristics
Paper holes and low reflection prohibited area
Supply voltage: +24 VDC ± 10%
Current consumption: Operating:
When feeding
slip paper to
the print
starting
position:
Mean - approx. 2.3 A,
approx. 1.4 seconds
Paper feed direction
10mm
(.39")
Make sure there are
no holes and low reflection
in this area of the paper
U925_eng.book Page 10 Thursday, July 25, 2002 9:15 AM