User`s manual

ManualsBrandsEpson ManualsNetwork CardUB E02

UB-E02 User’s Manual

Printed in China 2004.01

Introduction

The UB-E02, designed for EPSON

TM printers, is a 10BASE-T/100BASE-TX

Ethernet interface board.

This manual provides instructions, including a simple setup for operators of

POS systems in which the UB-E02 is installed so that the operators can use the

UB-E02 safely and correctly.

Key to Symbols

The symbols in this manual are identified by their level of importance, as

defined below. Read the following carefully before handling the product.

CAUTION:

Cautions must be observed to avoid minor injury to yourself, damage to

your equipment, or loss of data.

Note:

Notes have important information and useful tips on the operation of your equipment.

Caution Label

The following caution label is visible near the display module connector.

The label has the following meaning:

“The display module connector and the drawer kick-out connector use the

same type of the Ethernet connector; therefore, be sure not to connect the

Ethernet connector cable or the telephone line to the display module connector

or the drawer kick-out connector.”

Features and Functions

❏ Protocols: TCP, UDP, ICMP, IP, LP/LPR (for APD), TCP socket port (for

OPOS)

❏ Communication standard: 10Base-T/100Base-TX, Full duplex/half

duplex

❏ OPOS, JavaPOS, APD support

405223601

Summary of content (4 pages)

PAGE 1
UB-E02 User’s Manual 405223601 Copyright © Seiko Epson Corporation 2004 Printed in China 2004.01 Introduction The UB-E02, designed for EPSON ® TM printers, is a 10BASE-T/100BASE-TX Ethernet interface board. This manual provides instructions, including a simple setup for operators of POS systems in which the UB-E02 is installed so that the operators can use the UB-E02 safely and correctly. Key to Symbols The symbols in this manual are identified by their level of importance, as defined below.
PAGE 2
Part Names The following view shows the part names of the UB-E02. 10BASE-T/100BASE-TX Ethernet interface connector Power supply connector LED (green) LED (yellow) Push button Display module connector Drawer kick-out connector The display module connector on the TM printer cannot be used when the UB-E02 is installed. Note: This photograph shows the TM-H6000II printer with the UB-E02 installed.
PAGE 3
How to Set Up the UB-E02 Preparation Printing a Status Sheet Power on the printer. Then, hold down the push button on the interface card for more than 3 seconds. The printer prints the parameters for the UB-E02. You can check all setting values necessary (IP address, Subnet mask, Gateway address) for the network connection. Connection Set the setting of the host PC to match the network setting that you have confirmed with the status sheet.
PAGE 4
❏ Obtaining the TMNetWinConfig and the UB-E02 Technical Reference Guide For customers from North, Central, or South America, go to the following web site: http://pos.epson.com/ For customers from other countries, go to the following web site: http://www.epson-pos.com/ Select the product name from the “Select any product” pull down menu. EMC Standards Applied Product Name: UB-E02 Model Name: M155B The following standards are applied only to the interface boards that are so labeled.