Specifications

16. Using Peripherals with the USN52 L
USN52 L Operating Manual Page 109
Epson compatible MEMO DUMP All non-empty MEMOS
(If MEMO function is
enabled)
NOTE: A special cable is required for each type of device.
Refer to Chapter 2 or applicable section of this chapter.
16.2 Connecting a Peripheral Device
Peripheral devices are connected to the RS-232 I/O port on the
rear of the USN52 L. Special cables, available from Krautkramer,
To enable communication between the USN52 L and peripheral,
RS-232 protocol must set to match the connected device.
For printers, a printer driver must also be selected. The operat-
ing manual of the connected device will give required protocol set-
tings.
Select the appropriate printer driver as follows:
1. Turn on the USN52 L and select the lower level menus:
;
2. Frame the column containing the COPY MODE function:
or , or
3. Activate the PRINTER SELECT function:
4. Select the compatible printer name:
5. Return to the COPY MODE function:
RS-232 protocol is preset at the factory as follows:
BAUD RATE: 9600
LENGTH: 8 DATA BITS
PARITY: DISABLED
must be used. The specific cable required for each type of device
is specified in the applicable section of this chapter and in Chapter
2, Accessories and Peripherals.
Location of the RS-232 I/O port is shown below.
Rear Panel of the USN52 L