Specifications

Page 54 USN52 L Operating Manual
Note that fields may be designated as active during header
setup, which will prevent the user from entering information
in the memo field. Instead, the instrument will directly input
designated data directly into the active field as directed dur-
ing header setup.
If the header has not been formatted with the UltraDOC util-
ity, it will automatically become one blank field of 80 charac-
ters which can not be modified from the memo screen.
8.5 Entering Data Set Memo Information
This section explains how to enter information into the two
memo text lines on the memo screen. This is an optional
operation and is not required when naming, storing and re-
calling data sets. The memo screen is accessed in two dif-
ferent ways:
1. The memo screen will appear when a data set store
operation is performed with the memo enabled from the
lower level menu.
2. The memo screen will appear following a double press
of keys corresponding to the memo enable menu
box.
The memo screen contains two memo text lines and two
rows of selection characters. The memo text lines can con-
tain up to 40 characters each (for a total of 80 characters).
Any of the selection characters can be inserted anywhere in
the memo text lines except where a specific memo text field
was designated as active during the memo screen header
setup.
IMPORTANT: Look at Figure 1 while you read these instruc-
tions.
There are two flashing cursors visible on the memo screen.
The block cursor is visible on one of the two memo screens
and is moved by using the increment/decrement keys that
correspond to the desired memo text line ( keys 1 and
2). The second cursor is the underline cursor. It can be
found flashing under one of the selection characters and is
also moved with the corresponding increment/decrement keys
( keys 3 and 4).
8. Using the Data Set Memory