Specifications

USN52 L Operating Manual Page 57
To change characters entered on memo lines 1 or 2
• The menu select keys (Figure 1) allow you to move the
block cursor to the left or right without writing characters
on the memo text line.
• To replace a character on one of the memo lines, move
the block cursor to the position to be modified by using
the left key or by using either menu select key. When
the block cursor is in the desired position, select the
replacement character using keys 3 or 4. When
the replacement character is selected, it will be written in
the block cursor. To return the block cursor to the desired
position without modifying the existing characters, use the
right or left menu select key.
To exit the memo screen
• Press the Home key or or the menu level select key.
• The saved memo screen will be associated with the
current data set.
• Pressing the Power Off key while the memo screen is
active will cause the instrument to exit the memo screen
and will NOT save any new information entered in the
memo screen.
8.6 Naming Data Sets
The Data Set Naming screen is accessed by using the menu
select keys to indicate the data set menu box and then si-
multaneously pressing the corresponding key. When
the Data Set Naming screen appears, it contains one data-
set-name line and two lines of selection characters which
are very similar in appearance and operation to those on the
Memo screen.
IMPORTANT: Read these instructions
There are two flashing cursors visible on the data set naming
screen. The block cursor is visible on the data-set-name line
and is moved by using the increment/decrement keys that
correspond to the line ( key 2). The second cursor is
the underline cursor. It can be found flashing under one of
the selection characters and is also moved with the corre-
sponding increment/decrement keys ( keys 3 and 4).
8. Using the Data Set Memory