Specifications

Page 58 USN52 L Operating Manual
To enter characters on the data-set-name line
• Leave the block cursor in it’s initial position on the data-
set-name line
• Move the underline cursor (using key 3 or 4) to the
desired character.
• When the desired character is selected (by placing the
underline cursor under the character) note that the block
cursor on the data-set-name line contains that selected
character.
• Now move the block cursor to the next character position
(to the right) using key 2. Note that each time you
move the block cursor to the right, the selected character
will be “written” on the data-set-name screen at the new
and previous character position.
• The data-set-name line will accept up to 8 characters.
• To write a different character in the next data-set-name -
line position, move the block cursor to the new position
(using key 2) and then select the desired character
with the underline cursor using key 3 or 4.
• To move the block cursor without writing a character on
the data-set-name line, use one of the menu select keys
or the decrement key corresponding to the memo text
line
• To enter a character in the first position of the data-set-
name line, the underline cursor must first be moved
from it’s initial starting point (under the character 1). To
write a “1” in the first position of the data-set-name line,
use key 3 to move the underline cursor at least one
character to the right, then return it to the position below
the character “1”.
To change characters entered on the data-set-name line
• The menu select keys allow you to move the block cursor
to the left or right without writing characters on the data-
set-name line.
• To replace a character on the data-set-name line, move
the block cursor to the position to be modified by using
the left key or by using either menu select key.
When the block cursor is in the desired position, select
the replacement character using keys 3 or 4. When
the replacement character is selected, it will appear in
the block cursor. To return the block cursor to the desired
position without modifying the existing characters, use the
right or left menu select key.
8. Using the Data Set Memory