User Guide
Table Of Contents
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Using the Projector on a Network
- Wired Network Projection
- Wireless Network Projection
- Selecting External Network Detection Settings
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Viewing 3D Images
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Projector Features
- Adjusting the Menu Settings
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When "Not Supported" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions When a 3D Image Does Not Display Correctly
- Solving Projector or Remote Control Operation Problems
- Solving Network Problems
- Where to Get Help
- Technical Specifications
- Notices
152
Solutions to Problems with the Remote Control
If the projector does not respond to remote control commands, try the following solutions:
• Check that the remote control batteries are installed correctly and have power. If necessary, replace
the batteries.
• Make sure you are operating the remote control within the reception angle and range of the projector.
• Make sure the projector is not warming up or shutting down.
• Check to see if a button on the remote control is stuck down, causing it to enter sleep mode. Release
the button to wake the remote control up.
• Strong fluorescent lighting, direct sunlight, or infrared device signals may be interfering with the
projector's remote receivers. Dim the lights or move the projector away from the sun or interfering
equipment.
• If available, turn on one of the remote receivers in the projector's menu system, or check if all the
remote receivers were turned off.
• If you assigned an ID number to the remote control to operate multiple projectors, you may need to
check or change the ID setting (feature not available with all projectors).
• If you lose the remote control, you can purchase another from an authorized Epson reseller.
Parent topic: Solving Projector or Remote Control Operation Problems
Related references
Optional Equipment and Replacement Parts
Remote Control Operation
Related tasks
Replacing the Remote Control Batteries
Solutions to Panel Alignment Problems
If the panel alignment does not result in a satisfactory picture, try the following solutions:
• Make sure the Projection setting matches the installation position.
• Make sure the projection surface is not colored or textured. Project on a white surface with no texture.
• Leave the projector on for 10 to 15 minutes before adjusting the panel alignment.
• The projected image size should be at least 60 inches (152 cm) during panel alignment.
• If the image contains too much magenta, adjust the red and blue panels.
• If the pattern lines look fuzzy or out of focus, adjust the focus before performing the panel alignment.