User Guide
Table Of Contents
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Using the Projector on a Network
- Wired Network Projection
- Wireless Network Projection
- Selecting External Network Detection Settings
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Viewing 3D Images
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Projector Features
- Adjusting the Menu Settings
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When "Not Supported" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions When a 3D Image Does Not Display Correctly
- Solving Projector or Remote Control Operation Problems
- Solving Network Problems
- Where to Get Help
- Technical Specifications
- Notices
77
Adjusting Projector Features
Follow the instructions in these sections to use your projector's feature adjustments.
Shutting Off the Picture Temporarily
Using Picture in Picture
Projector Security Features
Using Advanced Image Adjustment Features
Saving Settings to Memory and Using Saved Settings
Saving the Lens Position and Using Saved Lens Positions
Shutting Off the Picture Temporarily
You can temporarily turn off the projected picture if you want to redirect your audience's attention during
a presentation. Any video action continues to run, however, so you cannot resume projection at the point
that you stopped it.
1. Press the Blank button on the remote control to temporarily stop projection.
2. To turn the picture back on, press the Blank button again.
Parent topic: Adjusting Projector Features
Using Picture in Picture
You can use Picture in Picture mode to view two image sources simultaneously (Pro Cinema 4050).
Note: You can display only HDMI video sources when using Picture in Picture mode. You cannot use
Picture in Picture while projecting 3D or 4K images.
1. Turn on the projector and switch to the HDMI image source you want to use.