Owner's Manual
Table Of Contents
- User's Guide
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Using the Projector on a Network
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Selecting the Language for the Projector Menus
- Adjusting the Image Position
- Focusing the Image
- Adjusting the Front Feet
- Image Shape
- Resizing the Image with the Zoom Setting
- Viewing 3D Images
- Remote Control Operation
- Pairing the Remote Control (LS500WATV/LS500BATV)
- Selecting an Image Source
- Image Aspect Ratio
- Color Mode
- Adjusting Gamma
- Controlling the Volume with the Volume Buttons
- Adjusting Projector Features
- Adjusting the Menu Settings
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image or Sound Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When "Not Supported" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions When a 3D Image Does Not Display Correctly
- Solutions to Sound Problems
- Solving Projector or Remote Control Operation Problems
- Solving Network Problems
- Where to Get Help (U.S. and Canada)
- Where to Get Help (Latin America)
- Technical Specifications
- General Projector Specifications
- Projector Light Source Specifications
- Remote Control Specifications
- Projector Dimension Specifications
- Projector Electrical Specifications
- Projector Environmental Specifications
- Projector Safety and Approvals Specifications
- Safety and Approvals Specifications for Latin America
- Supported Video Display Formats
- Notices
- Quick Setup Guide
- TV Installation Guide
8 Assembling the Screen
5. Insert four of the supplied M5 × 8 mm screws in each corner.
Note: Make sure there are no gaps between the frame pieces before you tighten the screws all the way.
Testing the Frame Position
1. Remove the jig from the front of the projector.
2. Remove the frame from the sheet.
3. Hang the frame on the wall brackets, with the screws facing the wall.
4. Move the frame left or right as needed to align it with the projected image, and make sure the arrow heads in the projected
image extend to the outer edges of the frame.
Note: If the image is not aligned, slightly adjust the position of the projector as needed.
Attaching the Screen Material
1. Remove the screen material from the tube and unroll it on the transparent sheet. The back of the screen should be facing you.
Caution: Do not lift the screen until after you have attached the frame.
Note: The back of the screen has a DOWNSIDE label attached. Make sure the side of the screen with the label is closest to the wall.
2. Center the frame on top of the screen material, with the screw holes facing up.
DOWNSIDE