User's Manual
Table Of Contents
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Remote Control Operation
- Pairing the Projector Remote Control
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image
- Focusing the Image
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Viewing 3D Images
- Controlling the Volume with the Volume Buttons
- Adjusting Projector Features
- Adjusting the Menu Settings
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image or Sound Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When "Not Supported" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions When a 3D Image Does Not Display Correctly
- Solutions to Sound Problems
- Solutions to Bluetooth Audio Problems
- Solving Projector or Remote Control Operation Problems
- Solutions to HDMI Link Problems
- Where to Get Help (U.S. and Canada)
- Where to Get Help (Latin America)
- Technical Specifications
- General Projector Specifications
- Projector Lamp Specifications
- Remote Control Specifications
- Bluetooth Specifications
- Projector Dimension Specifications
- Projector Electrical Specifications
- Projector Environmental Specifications
- Projector Safety and Approvals Specifications (U.S. and Canada)
- Supported Video Display Formats
- Notices
68
Note: You can select the Frame Interpolation and Noise Reduction settings only when the Image
Processing setting is set to Fine.
Parent topic: Adjusting the Menu Settings
Input Signal Settings - Signal Menu
Normally the projector detects and optimizes the input signal settings automatically. If you need to
customize the settings, you can use the Signal menu. The available settings depend on the currently
selected input source.
To change settings for an input source, make sure the source is connected and select that source.