Owner's Manual
Table Of Contents
- User's Guide
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Monitoring and Controlling the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Image Sharpness
- Adjusting the Projector's Brightness Level
- Turning On Dynamic Contrast
- Adjusting the Color Temperature
- Adjusting the RGB Offset and Gain
- Adjusting Gamma
- Adjusting the Hue, Saturation, and Brightness
- Adjusting Projector Features
- Adjusting the Menu Settings
- Using the Projector's Menus
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Installation Settings - Installation Menu
- Display Settings - Display Menu
- Feature Settings - Operation Menu
- Administration Settings - Management Menu
- Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Initial Settings and Reset Options - Initial/All Settings Menu
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image or Sound Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions to Image and Sound Syncing Problems
- Solutions to Sound Problems
- Solving Projector or Remote Control Operation Problems
- Where to Get Help (U.S. and Canada)
- Where to Get Help (Latin America)
- Technical Specifications
- Notices
- Quick Setup
135
• If you connected an extension power cable, try projecting without it to see if it caused interference in
the signal.
• If you connected an A/V system that does not support eARC/ARC to the HDMI2 (eARC/ARC) port, the
image may be distorted.
Parent topic: Solving Image or Sound Problems
Related references
Input Signal Settings - Signal I/O Menu
Image Quality Settings - Image Menu
Installation Settings - Installation Menu
Related tasks
Adjusting Image Sharpness
Solutions When the Image is Fuzzy or Blurry
If the projected image is fuzzy or blurry, try the following solutions:
• Adjust the image focus.
• Clean the projector lens.
• Check the lens for condensation.
Note: To avoid condensation on the lens after bringing the projector in from a cold environment, let the
projector warm up to room temperature before using it.
• Position the projector close enough to the screen, and directly in front of it.
• Adjust the Sharpness setting to improve image quality.
• If you are projecting from a computer, adjust the computer's resolution to match the projector's native
resolution, if possible.
Parent topic: Solving Image or Sound Problems
Related concepts
Projector Placement
Related references
Image Quality Settings - Image Menu
Related tasks
Focusing the Image with the Lens Button