Owner's Manual
Table Of Contents
- User's Guide
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Monitoring and Controlling the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Image Sharpness
- Adjusting the Projector's Brightness Level
- Turning On Dynamic Contrast
- Adjusting the Color Temperature
- Adjusting the RGB Offset and Gain
- Adjusting Gamma
- Adjusting the Hue, Saturation, and Brightness
- Adjusting Projector Features
- Adjusting the Menu Settings
- Using the Projector's Menus
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Installation Settings - Installation Menu
- Display Settings - Display Menu
- Feature Settings - Operation Menu
- Administration Settings - Management Menu
- Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Initial Settings and Reset Options - Initial/All Settings Menu
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image or Sound Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions to Image and Sound Syncing Problems
- Solutions to Sound Problems
- Solving Projector or Remote Control Operation Problems
- Where to Get Help (U.S. and Canada)
- Where to Get Help (Latin America)
- Technical Specifications
- Notices
- Quick Setup
79
box on the screen, press Enter, make any necessary adjustments and press Enter again. Repeat
this step as necessary for the other intersections.
Note: To save the adjusted panel alignment setting after exiting, select Memory > Save Memory in
the Display menu.
Parent topic: Using Advanced Image Adjustment Features
Adjusting the Color Tone (Color Uniformity)
You can use the Color Uniformity feature to manually adjust the color tone balance in the projected
image.
Note: These settings should be set by a professional color calibrator using specialized color calibration
tools in a controlled lighting environment.
Note: The color tone may not be uniform even after adjusting the color uniformity.
1. Press the Menu button.
2. Select the Management menu and press Enter.