Owner's Manual
Table Of Contents
- User's Guide
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Monitoring and Controlling the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Image Sharpness
- Adjusting the Projector's Brightness Level
- Turning On Dynamic Contrast
- Adjusting the Color Temperature
- Adjusting the RGB Offset and Gain
- Adjusting Gamma
- Adjusting the Hue, Saturation, and Brightness
- Adjusting Projector Features
- Adjusting the Menu Settings
- Using the Projector's Menus
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Installation Settings - Installation Menu
- Display Settings - Display Menu
- Feature Settings - Operation Menu
- Administration Settings - Management Menu
- Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Initial Settings and Reset Options - Initial/All Settings Menu
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image or Sound Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions to Image and Sound Syncing Problems
- Solutions to Sound Problems
- Solving Projector or Remote Control Operation Problems
- Where to Get Help (U.S. and Canada)
- Where to Get Help (Latin America)
- Technical Specifications
- Notices
- Quick Setup
88
Do not adjust image settings on a projector until after you transfer settings to it. Otherwise, you may have
to repeat your adjustments.
1. Turn off the projector and unplug the power cord from the projector's power inlet.
2. Connect a USB cable to your projector's Service port.
3. Connect the other end to any available USB port on your computer.
4. Press and hold the Menu button on the control panel or remote control as you connect the power
cord to the projector's power inlet.
5. When all of the projector lights turn on, release the Menu button.
The projector shows up as a removable disk on your computer.
6. Copy the pjconfdata.bin file from your computer to the removable disk.
Note: Do not copy any other files to the removable disk.
7. Once the file has copied, do one of the following:
• Windows: Open the My Computer, Computer, Windows Explorer, or File Explorer utility.
Right-click the name of your projector (listed as a removable disk) and select Eject.
• Mac: Drag the removable disk icon for your projector from the desktop into the trash.
All the lights start flashing to indicate that the projector's settings are being updated. When the lights
stop flashing, remove the USB cable from the projector. The projector enters standby mode.
Caution: Do not unplug the power cord while the lights are flashing. This could damage the
projector.
Note: If the projector does not turn off and the lights continue flashing, see the link below for a
solution.
Parent topic: Copying Menu Settings Between Projectors
Related references
Projector Light Status