Owner's Manual
Table Of Contents
- User's Guide
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Monitoring and Controlling the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Image Sharpness
- Adjusting the Projector's Brightness Level
- Turning On Dynamic Contrast
- Adjusting the Color Temperature
- Adjusting the RGB Offset and Gain
- Adjusting Gamma
- Adjusting the Hue, Saturation, and Brightness
- Adjusting Projector Features
- Adjusting the Menu Settings
- Using the Projector's Menus
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Installation Settings - Installation Menu
- Display Settings - Display Menu
- Feature Settings - Operation Menu
- Administration Settings - Management Menu
- Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Initial Settings and Reset Options - Initial/All Settings Menu
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image or Sound Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions to Image and Sound Syncing Problems
- Solutions to Sound Problems
- Solving Projector or Remote Control Operation Problems
- Where to Get Help (U.S. and Canada)
- Where to Get Help (Latin America)
- Technical Specifications
- Notices
- Quick Setup
98
Setting Options Description
Image Processing Fine
Fast
Improves the response speed for images
projected at high speed
Fine: improves the response speed for
images (Frame Interpolation in the Image
menu must be turned off)
Fast: disables Frame Interpolation, Noise
Reduction, and MPEG Noise Reduction
settings
HDMI IN EQ Level HDMI1
HDMI2
Adjusts the HDMI input signal level if there
is image static or noise, depending on the
device connected to the HDMI port
Auto: this is the recommended setting for
most cases
Low: select if there is noise when using a
short HDMI cable
Medium: select if the other settings do not
reduce the noise
High: select if there is noise when using a
long HDMI cable
Reset to Defaults — Resets all settings for the current input
source
EDID EDID (HDMI1)
EDID (HDMI2)
Describes the display capabilities of your
projector (if images are not displayed
correctly, you may be able to display them
by changing this setting)
EDID Mode: change this setting as
necessary according to the resolution of the
image
HDR10+: set to Off to correctly display
images when the current input source does
not support HDR10+