Owner's Manual
Table Of Contents
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Monitoring and Controlling the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Image Sharpness
- Adjusting the Projector's Brightness Level
- Turning On Dynamic Contrast
- Adjusting the Color Temperature
- Adjusting the RGB Offset and Gain
- Adjusting Gamma
- Adjusting the Hue, Saturation, and Brightness
- Adjusting Projector Features
- Adjusting the Menu Settings
- Using the Projector's Menus
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Installation Settings - Installation Menu
- Display Settings - Display Menu
- Feature Settings - Operation Menu
- Administration Settings - Management Menu
- Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Initial Settings and Reset Options - Initial/All Settings Menu
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image or Sound Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions to Image and Sound Syncing Problems
- Solutions to Sound Problems
- Solving Projector or Remote Control Operation Problems
- Where to Get Help (U.S. and Canada)
- Where to Get Help (Latin America)
- Technical Specifications
- Notices
101
Setting Options Description
Projection Front
Front/Ceiling
Rear
Rear/Ceiling
Selects the way the projector faces
the screen so the image is oriented
correctly
H/V-Keystone V-Keystone
H-Keystone
Adjusts image shape to rectangular
(horizontally and vertically)
Blanking Top
Bottom
Left
Right
Hides the edges of the screen if
there is noise from the input signal
High Altitude Mode On
Off
Regulates the projector's operating
temperature at altitudes above 4921
feet (1500 m)
Note: The cooling fans inside the
projector run faster and may sound
louder when this setting is enabled;
this is normal.
Reset Installation Settings — Resets all settings on the Installation
menu to their default values
Parent topic: Adjusting the Menu Settings