Owner's Manual
Table Of Contents
- Contents
- Introduction to Your Projector
- Setting Up the Projector
- Monitoring and Controlling the Projector
- Using Basic Projector Features
- Turning On the Projector
- Turning Off the Projector
- Selecting the Language for the Projector Menus
- Adjusting the Image Height
- Adjusting the Image Position Using Lens Shift
- Image Shape
- Resizing the Image with the Zoom Feature
- Focusing the Image with the Lens Button
- Remote Control Operation
- Selecting an Image Source
- Projection Modes
- Image Aspect Ratio
- Color Mode
- Adjusting Image Sharpness
- Adjusting the Projector's Brightness Level
- Turning On Dynamic Contrast
- Adjusting the Color Temperature
- Adjusting the RGB Offset and Gain
- Adjusting Gamma
- Adjusting the Hue, Saturation, and Brightness
- Adjusting Projector Features
- Adjusting the Menu Settings
- Using the Projector's Menus
- Image Quality Settings - Image Menu
- Input Signal Settings - Signal I/O Menu
- Installation Settings - Installation Menu
- Display Settings - Display Menu
- Feature Settings - Operation Menu
- Administration Settings - Management Menu
- Network Settings - Network Menu
- Image Quality Memory Settings - Memory Menu
- Initial Settings and Reset Options - Initial/All Settings Menu
- Maintaining and Transporting the Projector
- Solving Problems
- Projection Problem Tips
- Projector Light Status
- Solving Image or Sound Problems
- Solutions When No Image Appears
- Solutions When "No Signal" Message Appears
- Solutions When Only a Partial Image Appears
- Solutions When the Image is Not Rectangular
- Solutions When the Image Contains Noise or Static
- Solutions When the Image is Fuzzy or Blurry
- Solutions When the Image Brightness or Colors are Incorrect
- Solutions to Image and Sound Syncing Problems
- Solutions to Sound Problems
- Solving Projector or Remote Control Operation Problems
- Where to Get Help (U.S. and Canada)
- Where to Get Help (Latin America)
- Technical Specifications
- Notices
81
8. Select the Start Adjustments setting and press Enter.
9. Select the area of the screen that you want to adjust and press Enter.
Note: Adjust the outer areas first, then select All to adjust the entire screen.
10. Select the color you want to adjust. Use the left arrow button to weaken the color tone and the right
arrow button to strengthen the color tone.
11. Press Esc to return to the area selection screen.
12. Repeat these steps for each area you want to adjust and for each adjustment level.
13. Press Menu or Esc to exit the menus.
Parent topic: Using Advanced Image Adjustment Features