Specifications

4-44 OS and Drivers Rev. I
7. Add the following description to the AUTOEXEC.BAT of MS-DOS with a text editor, and
save it. The following is the example of the having the driver file in the C:\NWCLIENT\
directory. In case of having it in the other directory, describe as "CD [the directory name]".
CD NWCLIENT
LSL
E100BODI
IPXODI
NETX
8. Turn off the IM-800 and connect it to the network.
9. Turn on the IM-800 and restart MS-DOS.
Installing the Serial Port Driver
Note
COM1/COM2 can be used without installing this driver. In case of using COM3/COM4, it is necessary
to install this driver.
For installing this driver, it is necessary for the CD-ROM drive to work normally.
Install the serial port driver by the following procedure.
1. Turn on the IM-800 and start MS-DOS.
2. Insert the Driver CD-ROM for the IM-800 in the CD-ROM drive.
3. Copy \Dos62\Serial\ITE.COM to the optional directory in the hard disk. For example,
copy it to the C:\DOS\ directory.
4. Input the following form the command prompt of the MS-DOS and start it.
C:\ITE.COM [COM3=xxxx] [COM4=yyyy]
The parameter means as follows.
COM3=xxxx :This specifies the Port address of COM3.
COM4=yyyy :This specifies the Port address of COM4.
The parameter can be omitted. In this case, the following default value is set.
COM3 :3E8h/IRQ11
COM4 :2E8h/IRQ10
5. Input the following from the command prompt of the MS-DOS to finish.
C:\ITE.COM -r
6. Input the following from the command prompt of the MS-DOS to display the Usage.
C:\ITE.COM /?
Installing the Touch Panel Driver, MSR utility and the Other Devices
See the Installation of Other Drivers section on page 4-45.