User Manual

270
LCD screen message Condition/solution
Paper settings for XX do
not match the Print
Settings. Pull out Paper
Cassette 1 or Paper
Cassette 2 to place the
following paper. XX XX
Load paper that matches the print settings in the paper cassette, then
change the paper or print settings. If you do not want to display this message
next time, turn off the Paper Configuration setting on the control panel.
The paper size and type
set in XX does not
match specified Print
Settings.
No paper has been
loaded that matches the
paper size setting.
Change the print settings according to the paper size loaded in the paper
cassette, then change the paper or print settings. If you do not want to
display this message next time, turn off the Paper Mismatch setting on the
control panel.
Recovery mode An error has occurred during firmware updating. Connect your product using
a USB cable and try updating the firmware again. If you still receive this error
message, contact Epson for support.
Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD screen, or lights on the control panel will advise you when these parts need replacing. If this
happens during the standard warranty of the product, the exchange of the product or replacement of the
pads is covered under the standard warranty. If the product is out of warranty, the pads can be replaced
by any Epson authorized service provider. The waste ink pads are not a user-replaceable part.
Parent topic: Solving Problems
Related concepts
Uninstall Your Product Software
Related references
External USB Device Specifications
Memory Card Specifications
Related tasks
Checking for Software Updates