Printer User Manual
Table Of Contents
- FRONT MATTER
- TABLE OF CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP THE PRINTER
- CHAP 2-PAPER HANDLING
- CHAP 3-USING THE PRINTER
- CHAP 4-USING SOFTWARE AND GRAPHICS
- Using the LQ-2550 With Application Programs
- Computer-Printer Communication
- Enhancing Your Printing
- Graphics
- User-Defined Characters
- Designing Your Characters
- Design Grids
- Data Numbers
- Sending Information to Your Printer
- Printing User-Defined Characters
- Copying ROM Characters to RAM
- Letter Quality Characters
- Proportional Mode Characters
- Superscripts and Subscripts
- The Graphics Command
- Column Reservation Numbers
- A simple Graphics Program
- Using Hand-Calculated Data to Print Graphics
- Using Software and Graphics
- Mixing Print Styles
- CHAP 5-MAINTENANCE AND TRANSPORTATION
- CHAP 6-TROUBLESHOOTING
- Troubleshooting
- Problems and Solutions
- The Printer Does Not Print
- The Printer Stops Printing
- The Printout is Spaced Incorrectly
- The Printout is Faint or Uneven
- The Printout is Not what You Expect
- Single Sheets Do Not Feed Properly
- Continuous Paper Does Not Feed Properly
- Cut Sheet Feeder Does Not Load Paper Correctly
- The Short Tear-Off Feature Does Not Work Properly
- Color Printing Is Not What You Expect
- Data Dump Mode
- CHAP 7-USING PRINTER OPTIONS
- CHAP 8-COMMAND SUMMARY
- APPENDIX A-TECHNICAL SPECIFICATIONS
- GLOSSARY
- INDEX
Chapter 7
Using Printer Options
The Cut Sheet Feeder
......................................
7-2
Installation
.............................................
7-2
Loading paper
..........................................
7-6
Testing the printer in the cut sheet feeder mode
.............
7-9
Loading envelopes
.....................................
7-11
Using the cut sheet feeder
...............................
7-13
Switching between the cut sheet feeder
and continuous paper........................................................................7-17
Loading single sheets
...................................
7-18
Removing the cut sheet feeder
...........................
7-20
The Pull Tractor
..........................................
7-21
Installation
............................................
7-21
Loading paper
.........................................
7-24
Removing the pull tractor
...............................
7-31
Interface Boards..
........................................
7-33
Choosing an interface
...................................
7-33
Compatible interfaces
...................................
7-33
Installing the interface board.
............................
7-34
The Multi-Font Module
...................................
7-45
Installation
............................................
7-45
Selecting a Font
........................................
7-47
Using Printer Options
7-1