Printer User Manual
Table Of Contents
- FRONT MATTER
- TABLE OF CONTENTS
- INTRODUCTION
- CHAP 1-SETTING UP THE PRINTER
- CHAP 2-PAPER HANDLING
- CHAP 3-USING THE PRINTER
- CHAP 4-USING SOFTWARE AND GRAPHICS
- Using the LQ-2550 With Application Programs
- Computer-Printer Communication
- Enhancing Your Printing
- Graphics
- User-Defined Characters
- Designing Your Characters
- Design Grids
- Data Numbers
- Sending Information to Your Printer
- Printing User-Defined Characters
- Copying ROM Characters to RAM
- Letter Quality Characters
- Proportional Mode Characters
- Superscripts and Subscripts
- The Graphics Command
- Column Reservation Numbers
- A simple Graphics Program
- Using Hand-Calculated Data to Print Graphics
- Using Software and Graphics
- Mixing Print Styles
- CHAP 5-MAINTENANCE AND TRANSPORTATION
- CHAP 6-TROUBLESHOOTING
- Troubleshooting
- Problems and Solutions
- The Printer Does Not Print
- The Printer Stops Printing
- The Printout is Spaced Incorrectly
- The Printout is Faint or Uneven
- The Printout is Not what You Expect
- Single Sheets Do Not Feed Properly
- Continuous Paper Does Not Feed Properly
- Cut Sheet Feeder Does Not Load Paper Correctly
- The Short Tear-Off Feature Does Not Work Properly
- Color Printing Is Not What You Expect
- Data Dump Mode
- CHAP 7-USING PRINTER OPTIONS
- CHAP 8-COMMAND SUMMARY
- APPENDIX A-TECHNICAL SPECIFICATIONS
- GLOSSARY
- INDEX
6. You can choose to have the printer eject the sheets with the printed
side facing downward or upward. To have the printer eject the sheets
with the printed side facing downward, pull the front lever on the
right side of the cut sheet feeder forward. To eject the sheets with the
printed side facing upward, push this lever back.
If you eject the sheets with the printed side facing downward, the
paper is collated as it prints. If you eject the sheets with the printed
side facing upward, sheets are fed in reverse order but more sheets
can be stacked in the cut sheet feeder.
Caution: Never
move this lever
during
printing.
Testing the printer in the cut sheet feeder mode
When you perform the cut sheet feeder self test, the printer counts the
number of lines
on
the page and prints out this number at the bottom of
the first page. The number of lines counted by the printer becomes the
default page length setting. This setting, however, can be overriden by
SelecType or by software commands.
Using Printer Options
7-9