Installation guide

Quadro Manual I: Installation Guide Step 2: Configuring the QuadroCS
Step 2: Configuring the QuadroCS
The QuadroCS does not re-
quire further network
configuration in two cases:
• The QuadroCS is connected behind a basic
router that is compatible with the QuadroCS’s
implementation of STUN
• The QuadroCS is connected directly to the Inter-
net and your ISP supports DHCP. There are no
other router devices between the QuadroCS and the
DSL or cable modem and you get the IP address
assigned automatically by the ISP.
Your QuadroCS is now connected properly to the Internet. You may customize the follow-
ing settings
• if you want to enter a unique name for the QuadroCS LAN Settings -
• Regional Settings it is important that you properly configure your country and
•
is static IP or DHCP you will need to know whether DHCP is
of the default gateway and the IP address of the Domain
• e
QuadroCS’s firewall to make it easily accessible for management.
's LAN port, log in and complete
e Basic Configuration as described in step 2.1 and 2.2.
time zone settings.
WAN IP Settings
If your WAN uplink
supported or not.
If DHCP is not supported, you need to know the WAN IP address, the subnet
mask, the IP address
Name Server (DNS).
Your ISP should have provided you with this information when you installed
your Internet access. Otherwise, you will need to contact your ISP to request it.
Firewall - if your QuadroCS is connected behind a router, disable th
To customize the settings, connect a PC to the QuadroCS
th
QuadroCS (SW Version 3.0.x) 12