Technical data
64
4.3.8 “CONNECTING MODE” menu
In connecting mode you can teach-in the internal sensors of the WDC7000 to other WDC7000
stations and to the HomeMatic central control unit. To do this, you must set the corresponding
connection partners and the WDC7000 to teach-in mode.
CONNECTING MODE OK
- To launch teach-in mode touch “OK” and the following appears:
CONNECTING
The WDC7000 is now in teach-in mode. Once the teach-in procedure has been completed suc-
cessfully, teach-in mode and the conguration menu are exited. If no teaching-in is performed
for 20 seconds, teach-in mode and the conguration menu are exited.
4.3.9 “CLEANING” menu, cleaning mode
As the display is touched on a regular basis this can make it dirty, so it must be wi-
ped with a dry linen cloth from time to time (a cleaning cloth for spectacles is ideally
suited to this task; do not use any cleaning uids as this could damage the display).
To ensure that you do not change any settings on the station when wiping the dis-
play, you can use cleaning mode, which locks all touch elds for 20 seconds.
- Select the “CLEANING” menu:
NEXT CLEANING ENTER
- Touch “ENTER” and the following appears:
CLEANING START
- Touch “START” and the following appears:
CLEANING WAIT
- You can now clean the display. After 20 s the normal display will reappear.
4.3.10 “LIVE MODE” menu, calling the current weather data trend
In this mode, you can touch an additional eld to prompt the combination sensor to send its
measured data at 1 second intervals for 10 seconds. So a single touch is all that is needed to