User Manual

13
Make a note of the orientation; the connection cable of the rainfall sensor can be
found at one side.
• Remove the count rocker.
Make a note of the orientation; there is a small magnet at one side of the count
rocker.
• Now clean the components of the rain gauge. Think also of the drain hole in the plastic lower
part of the rain gauge which you have pushed downwards at the metal pipe.
• To reassemble, place the count rocker first of all in the holder.
For this, the magnet of the count rocker has to
belocated on the side which points to the cable.
The two lower trapezoid pins have to be inserted
into the lower part of the holder correctly.
Only in this manner is it guaranteed that the count
rocker can be moved easily.
F
F
F
1 - Vollmond
2 - Zunehmend
3 - Neumond
4 - Abnehmend
Remove cover:
- turn left
- pull down cover
- lift off upper cone
Mount cover:
- snap in cover
- turn right
• Insert the rainfall sensor into its holder. It will hold
the count rocker firmly automatically.
Only one orientation is correct; the cable
of the rainfall sensor and the magnet of the
count rocker have to be on the same side;
the plastic nib on the other side has to be
inserted precisely into the holder, look at
the circle in the picture on the right.
F