Operation Manual

If you add a MAX! Cube to your system later, you

must reset all devices including the MAX! Wall Ther-

mostat

to the initial state prior to teach-in to the

MAX! cube. All settings including your weekly pro-

les are deleted in this process.

10.2. Teaching-in MAX! components at the

MAX! Wall Thermostat

(without MAX! Cube)

With the MAX! Wall Thermostat

you can set up a sing-

le room solution with up to 8 MAX! Radiator Thermostats

and up to 8 window Sensors. This solution can be operated

without the MAX! Cube. For this purpose teach-in the de-

vices directly to the MAX! Wall Thermostats

. These then

take over the settings of the MAX! Wall Thermostat

(e.g.

mode, temperature, weekly program).

These single room solutions can be connected only

via a MAX! Cube (see above).

The MAX! Eco Switch cannot be integrated in a sin-

gle room solution. A MAX! Cube is necessary for the

integration of this button.

To teach-in your components proceed as follows:

• First switch the teach-in partner (e.g. the MAX! Radiator

Thermostat) according to teach-in mode.

• Now enable the teach-in mode on the MAX! Wall Ther-

mostat

by pressing and holding down the OK button.

• The antenna symboll ( ) is displayed, along with the

teach-in time remaining in seconds. The teach-in time

is 30 seconds.

• After teaching-in was successfull, the MAX! Wall Ther-

mostat

switches into the standard operating mode.