User Manual

- To choose another sensor, press the key ”SENSOR” long till the dis-

play in the display panel B disappears and at right the symbol for the

sensor address is blinking.

- Now press the key ”SENSOR” frequently short, till the required sensor

address and in display panel A the data of this sensor is displayed.

- If you don´t press any key for 10 seconds or shortly press the key

”MIN/MAX” or ”SELECT”, the device goes back to normal mode.

Now the data of display panel B appears again (indoor sensor or the

selected outdoor sensor).

•

You can only choose active sensors, that means, the base station

must already received data from this sensor at earlier time. The

unit skips not occupied addresses.

•

By choosing sensors 1...8 the water symbol appears.

•

By choosing the combination sensor the sensor address ”9” ap-

pears.

•

By choosing the indoor sensor no sensor address appears.

9.2.2. Display panel B - Indoor or outdoor sensor

In the base setting the panel B shows the indoor tempera-

ture and the indoor air humidity.

If required, you can allocate any sensor to this panel.

- For choosing a sensor, press the key ”SENSOR” frequently short, till the

required sensor address and in display panel B the data of this sensor

is displayed.

•

You can only choose active sensors, that means, the base station

must already received data from this sensor at earlier time. The

device skips not occupied addresses.

•

By choosing the combination sensor the sensor address ”9” ap-

pears.

•

By choosing the indoor sensor no sensor address appears.

• If the device is still in the selection mode for display panel A,

please wait either, till the panel B is displayed again, or press

the key ”SENSOR” long, till display panel B appears again.

Now the sensor selection for display panel B is activated.