Operation Manual

47
Setting the time zone
The time zone is required for the calculation of the sunrise
and sunset times.
Enter the difference to GMT (Greenwich Mean Time).
The following values apply for Germany:
• Daylight saving + 2
• Winter time + 1
Enter the current value for your time zone using the keys „+“
and „-“.
All settings have been made at this time for correct operation
of the weather station. The extended settings are not required
for normal operation.
Now press „EXIT“ to leave the configuration mode and return to
normal mode. Now the base station is back in normal mode.
Press the „NEXT“ key to make further settings and to bring
up the display for selecting the unit of measurement for
temperature measurements
Selecting the unit of measurement for
temperature measurements
The display of the unit of measurement for temperature
measurements is made in fields “INDOOR” and
“OUTDOOR” and can be
switched between °C and °F.
Use the “+” and “-” keys to set the desired unit of
measurement.
Press the “NEXT” key to bring up the rain sensor calibration.
Entering the alignment value
The rain gauge has been set to a high degree of accuracy ex
works so that you normally do not need to align it.
Simply press „NEXT“ to take over the factory settings.
Otherwise the alignment value will have to be determined
first of all in normal mode (see chapter 13 d) on page 56).
Enter the previously determined alignment value using the
keys „+“ and „-“.
Press „NEXT“ to set the unit for measuring rain.
-
+
time
zone
terminating
configura-
tion
extended
settings
EXIT
NEXT
or
-
+
alignment
value
NEXT
-
NEXT
+
tempe-
rature unit