Operating instructions

45
Set the latitude using the keys „+“ and „-“.
Example: 52.5°, input: 525
Press the „NEXT“ key. After that, you can enter the longitude.
The display shows this as „LO“ („Longitude“).
Set the longitude using the keys „+“ and „-“.
Example: 13.4°, input: 0134
Press the key „NEXT“ and now set the time zone. The display
shows „ti”.
Setting the time zone
The time zone is required for the calculation of the sunrise
and sunset times.
Enter the difference to GMT (Greenwich Mean Time).
The following values apply for Germany:
• Daylight saving + 2
• Winter time + 1
Enter the current value for your time zone using the keys „+“
and „-“.
All settings have been made at this time for correct operation
of the weather station. The extended settings are not required
for normal operation.
Now press „EXIT“ to leave the configuration mode and return to
normal mode. Now the base station is back in normal mode.
Press the key „NEXT“ to make extended settings and go to
the balancing of the rain sensor.
Entering the alignment value
The rain gauge has been set to a high degree of accuracy ex
works so that you normally do not need to align it.
Simply press „NEXT“ to take over the factory settings.
Otherwise the alignment value will have to be determined
first of all in normal mode (see chapter 13 d) on page 56).
Enter the previously determined alignment value using the
keys „+“ and „-“.
Press „NEXT“ to set the unit for measuring rain.
-
NEXT
+
latitude
-
NEXT
+
longitude
-
+
time
zone
terminating
configura-
extended
settings
EXIT
NEXT
or
-
+
alignment
value
NEXT