Installation

(c) 2014 EQ Acoustic
[e-mail] | Tel [phone] | www.eqacoustics.com
Wait 48 hours for the adhesive to cure BEFORE fitting your treatment to the walls.
Failure to follow this step will not allow the adhesive to bond effectively.
Note that Flexi-Fit is not recommend for use on ceilings.
Step 4:
Corner Cubes
6 to 12 tabs
Corner Traps:
8 to 12 tabs
Large tiles:
Classic Wedge 60
ColourPanel 60
4 to 8 tabs
Small tiles:
Classic Wedge 30
4 tabs
Fit one set of tabs to your acoustic foam and the other to your wall surface.
You must activate the adhesive by compressing the tab hard into the foam. Then do the same to the tabs on the wall
Recommended quantities below. Use more tabs in areas where the product may be disturbed.
Step 3:
Snip each of the 12cm lengths into 4 x 3cm pieces
Step 2:
Separate each of the 32 pairs of hook and loop strips
Step 1:
Flexi-Fit tabs provide a simple and removable way of tting
acoustic treatment to walls in recording rooms and studios.
Ensure your walls and clean and free from dust before starting.
Please note that adhesion with all surfaces cannot be
guaranteed.
Flexi-Fit 32 Fitting Guide