User's Manual

Adjust tightness of running belt, All treadmills shall be adjusted for tightness before delivery and
after installation. However, the running belt may be loosened after a period of use. For
example,The treadmill had stopping and slipping question during exercise.Adjust bolts of running
belt with the left and right synchronous as per clockwise direction to half a circle as the unit when
this phenomenon occurs.The feet is on the running belt which will slip if it is too loose. But it is not
good to be too tight. It is easy to increase the load of the motor and damage the motor,running belt
and roller etc.
Running belt deviation adjustment
All treadmills need to be adjusted the running belt before delivery and after installation.But the
running belt may be deviated after a period of use which may be caused by the following reasons.
①.The main body is not placed smoothly.
②.The feet of users are not in the center of the running belt.
③.The feet of users are uneven force
It will be returned to normal after a few minutes of no-load rotation if deviation is caused by man-
made.It should be adjusted with 6mm wrench at a half circle as the unit for deviation of non-
recover automatically.
Please adjust left bolt with clockwise or right bolt with counterclockwise if running belt is left
deviation.
Please adjust right bolt with clockwise or left bolt with counterclockwise if running belt is right
deviation.
The running belt deviation is not within the scope of warranty. And it is mainly maintained by the
user according to the manual. Running belt deviation will seriously damage the running belt. The
users must be found and corrected in time.
1.lubrication
The running is used for a period of time, it must be lubricated with special methy silicone oil.
Advice
Use time less than 3 hours per weeks lubricate once every 5 months
Use time 4-7 hours per week lubricate once every 2 months
Use time over 7hours per week lubricate once a month
Do not lubricate too much. It is not the more lubricants the better. Remember: Proper lubrication is
an important factor in improving the life of the treadmill.
As for the way to check if you need to add lubricant. Just grab the running belt and touch the
middle of the running belt back with your hands as much as possible.You don’t need to add
lubricant if you have silicone on your hand (a little damp) You have to add lubricant if the pad is dry
and there is no silicone on your hand.
the step of lubricate on the running plate (as shown right picture) Stop running for running belt and
fold the machine.
Lift the running belt of the underside of the main body,Put the oil pot as far as possible into the
middle of the running belt. And spray methyl silicone oil inside of the running and both sides.
You can make use of the treadmill speed of 1km/h to evenly lubricate and step on the running belt
from left to right. After a few minutes, the methyl silicone oil can be completely absorbed by the
running belt.
All treadmills have been adjusted before leaving
the factory and after installation. However, after
a period of use, there may be slack and slipping,
which is mainly adjusted by the user.
Adjustment steps:
① Use a wrench to turn the motor parallelism
adjustment bolt counterclockwise by half a turn
② Turn the belt tension bolt half a turn clockwise
Note: Clean the belt and pulley groove regularly
Adjustment of the motor belt (as shown on the right)
-21--20-