Installation Guide

Functions
Your SweepMop is an all-in-one appliance which lets you sweep and mop.
It can also clean itself with the press of a single button.
It can clean both wet and dry spills on floors.
Assembly of SweepMOP
Insert the Handle into the Connecting Rod, as shown at point “A”
Insert the other end of the Connecting Rod into the Powerhead Column, at point “B”
General Instructions
Note: To disassemble,
push a pointed tool into
the holes on the
Connecting Rod (at
points A & B) to unlock
the piece and pull apart.
A
B
Handle
Powerhead
Powerhead
Column
Connecting
Rod
To prevent malfunction, please observe the following:
Place the SweepMOP in an environment below 32°F (0°C) or above 122°F (50°C).
Place the SweepMOP in an area away from direct sunlight and heated surfaces.
Use the SweepMOP on hard surface floors, but not on carpets, rough floors or on the wall.
It also should not be used for polishing floors.
It cannot remove large chunks of trash and these should be cleared before using the
SweepMOP for normal cleaning.
The Cover must be closed when the SweepMOP is running and when it is self-Powerhead
cleaning. After cleaning the floor, the ground may be wet and slippery. Be careful not to fall.