Super Combo Model: 4400
WARRANTY INFORMATION Your appliance is protected by this warranty under normal, personal, family or household use (1Year), and limited commercial use (90 days), in USA and Canada. WARRANTY Consolidated Brands undertakes to the consumer-owner to repair or, at our option, to replace any part of this product which proves to be defective in workmanship or material under normal personal, family or household use, in the USA and Canada, for a period of one year from the date of original purchase.
EXCLUSIONS In no event shall Consolidated Brands be liable for incidental or consequential damages or for damages resulting from external causes such as abuse, operation misuse, neglect, alterations, normal wear and tear, incorrect voltage or acts of God. This warranty does not cover service calls which involve defective workmanship, damage due to other products while combined use with this product or materials covered by this warranty.
1200 rpm Note: All rights reserved.
Lint Free Maintenance Portability Kit (Accessory Part# 1070 sold separately) where needed.
Factory supplied accessories Vent Adapter
Handling Please handle the machine carefully and use appropriate means while lifting and moving the machine so that it does not get damaged. Do not drag the machine to avoid damage to your flooring and also to the machine. Do not hold on to protruding parts when lifting. Do not install the washing machine outdoors or in an area exposed to freezing conditions. Frozen hoses can tear/burst.
This Washer dryer must be connected to an individual circuit identical to the one specified on the rating plate of the loading port protected by fuses or circuit breaker conforming to local codes. Note: If the electrical power supply does not meet the specifications listed above, please call a licensed electrician.
1200 rpm 1200 rpm 1200 rpm 1200 rpm
Dispensers A and C, for wash and pre-wash detergents, have blue compartments within them. These compartments are only for liquid detergents. Please do not put powder detergents in them. Powder detergents should be placed directly in the dispensers. Please leave the blue compartments in place.
Press this button to select the Time Dry cycle. The symbol will be displayed. Press this button to run a refresh cycle if the machine is off. If the machine is on, press the button to chime on or off Displays the selected Program, such as the temperature, spin speed, remaining time, rinse times, water level, and error messages. Press this button to select the dry level for a Sensor Dry cycle. Press this button to select the sensor dry cycle. The symbol will be displayed.
How to Run a Wash Cycle Turn the dial to align with one of the 14 programs depending on the laundry, then press the START/PAUSE button to run the selected wash program. How to Run a Wash Cycle and Dry Cycle Turn the dial to select one of the 14 wash programs depending on the laundry, then press either the Sensor Dry button, or Time Dry button. If a Time Dry cycle is selected, press this button again, to select the desired dry duration. Then press START/PAUSE button to run both the wash and dry programs.
The symbols on labels of your garments will help you in choosing the suitable wash program, the right temperature, wash cycles, and ironing methods. Please review the chart below. 2. Close the water faucets and disconnect the inlet hoses. There should be no water in the hoses where they attach at the back of the machine.
Switch off the Washer - Dryer The pump impeller wheel located behind the water filter, must be able to rotate. Remove detergent residue and fluff from the pump cover thread and pump housing. Remove the cap from the Fabric Softener Run a rinse program without any laundry in the drum.
to remove on Bleach if necessary. rinse.
Ink Some Apply commerical rust remover, Rinse. Or, if safe for fabric, boil stained article in solution of 4 teaspoons of cream of tartar to 1 pint water.
DIAGNOSTIC MENU Description Code Component E1 Door close Door Switch E2 Drain Drain Pump E3 Water inlet Pressure Switch E4 E5 Motor Thermal Protector +Electronic Module E6 Communication between Communication display & electronic module Cable E8 Not Drying Temp. sensor (@rear-bottom of tub) E9 Not Drying Temp. sensor (@front of heater housing) Water level sensor E10 E11 Not Drying Temp.