CREF 45 SS Manual

Installation
When transporting the refrigerator, keep it in an upright position. Do not tilt the Refrigerator at
an angle of more than 45°.
Place the appliance away extreme heat and cold. It is not designed to be in direct sunlight or
outside.
Before connecting the refrigerator to power, let it stand upright for at least 4 hours.
Check the plug and cord before you connect the power and make sure it is a properly grounded
115/60 Hz outlet.
The Refrigerator is designed for recessed installation.
Place the Refrigerator on a flat level surface, leaving 2 inches (5 cm) on either side and at
least 3 inches (8 cm) between back of appliance and the wall. Allow sufficient clearance (160°)
for the door to open completely.
The feet of the appliance can be adjusted to make it level. Turn counterclockwise to raise and
clockwise to lower.
Technical Specifications
Model
Capacity
Voltage
Current
Refrigerant
Net Weight
Product Dimensions (HxWxD)
CREF 45 SS
4.5 cu ft
115V 60Hz
0.8A
R600a, 0.8 oz
52.1 lbs
32.1 x 20.3 x 22.2 (inch)
Door Reversal Instructions
The Refrigerator is built with a reversible door which lets you open it from either the left or right
side. In order to reverse the opening of the door, transfer the hinges and screws indicated in
the figure below from one side to the other.
2