TABLE OF CONTENTS Helpful 6 Pr-installation. Diagram of the Comb O 7 Installation Instructions 8 Unpacking reveling e 9 Electrical 10 Plumbing . 11 Ventilation 12 Recessed, Closet, ADA COMPLIANCE ..o e 15 Program Selection Chart ..o 16 Operating Inst Ructions -« gooier v 17 Control Panel i e 18 Display Panel ..o 19 Understanding Fabric Care Labels e, 20 WINTERIZING. 21 Maintenance ..o 21 Stain Removal Chart 22 Troubleshooting . 24 Diagnostics Menu.
WARRANTY INFORMATION Your appliance is protected by this warranty under normal, personal, family or household use (year, and limited commercial use (90 days), in USA and Canada. WARRANTY Consolidated Brands undertakes to the consumer-owner to repair or, at our option, to replace any part of this product which proves to be defective in workmanship or material under normal personal, family or household use, in the USA and Canada, for a period of one year from the date of original purchase.
EXCLUSIONS In no event shall Consolidated Brands be liable for incidental or consequential damages or for damages resulting from external causes such as abuse, operation misuse, neglect, alterations, normal wear and tear, incorrect voltage or acts of God. This warranty does not cover service calls which involve defective workmanship, damage due to other products while combined use with this product or materials covered by this warranty.
TECHNICAL A Model 4400N Rated Voltage 13A Washing input power 240 W $Spin input power 450 W Capacity 13 Abs/ 6 kg Spin Speed 1200 rpm Programs 14 Water pressure (psi) / Dimensions (HxWxD) 33.5x23.6x22 (in) / 85x60x55.8 (cms) Net Weight 1611bs /73 kg @. Intertwine 4007606 us N® 4007606 CANADA The ETL Listed Mark is the legal equivalent to the UL and CSA Listed Marks Note: All rights reserved.
INTRODUCTION Congratulations on your new Super Combo. In addition to Its contemporary design, this is a highly sophisticated engineered product that will give you many years of satisfaction. Here are some of the best reasons for buying your Combo 1. Space Saving By combining the two functions of washer and dryer in one unit, the space taken for the second unit, i.e. separate dryer, is saved. 2. Placement Options The Washer-Dryer's sleek design makes it a perfect appliance for any Kitchen or Laundry Room.
IMPORTANT SAFETY INSTRUCTIONS Your safety and that of your children Your Combo Washer-Dryer has been built in compliance with safety regulations, to protect you and your family. WARNING To reduce the risk of fire, electric shock, or injury to persons when using your appliance, follow basic precautions, including the following: Read all instructions before using the appliance. 2.
LI\ AN g The model number and the serial number are on the A CAUTION A hale affixed to the back of the unit. These numbers ara also available on the front of the cabinet behind NOT OPEN You should note the modal and seal umber of CAUTION: TO REDUCE THE RWK OF this unit in the space provided. Retain this booklet Took: pom anent record of your purchase to ald In Gov ER (O BACK. | N Urea | Identification In he Evert of theft. SERVICE PANTS aDE . REAPER SERVICING TO QUALIFIED SERVICE MODEL¥ PROFESSIONALS.
DIAGRAM OF THE COMBO WASHER-DRYER Drain Hose Drum Detergent Door Dispenser Shipping Rod Coin Trap Factory supplied accessories & @ O Inlet hose (2} U-Connector for Drain hose Blanking Caps (2) Vent Adapter
L5 Handling Please handle the machine carefully and use appropriate means while lifting and moving the machine so that it does not get damaged. Do not drag the machine to your floor and, or, to the machine. Do not hold on to protruding parts when lighting Disposing of the packing The shipping package has protected your new washing machine on its way to your home. All packaging materials are non-politicking and recyclable.
UNPACKING, LEVELING & POSITIONING Remove the packing and check that the Washer-Dryer is undamaged. If you have any doubt, do not use the Washer-Dryer and call Customer Service. Keep all packing parts (plastic bag, foam rubber, screws, etc.) out of the reach of children since they could be dangerous. Important: The inside of the Washer-Dryer consists of a free floating drum that is affixed with shipping rods at the back of the cabinet during transport (Fig.1).
ELECTRICAL CONNECTION Connect the plug to a power outlet 110V/60Hz with minimum 15 Amps. Make sure that the voltage and frequency available correspond with those stated on the serial number plate located on the machine. Do not use adapters or extension cords since they could result in overheating and numb out.
PLUMBING CONNECTING TO THE WATER FAUCET Please read the following steps carefully 1. Connect the straight end of the hot-water hose to the hot-water faucet (Fig.5) 2. Connect the straight end of the cold-water hose to the cold-water faucet (Fig.5) 3. Connect the L-shaped end of the hot-water hose to the inlet valve marked “H” (Fig.6) 4. Connect the L-shaped end of cold-water hose to the inlet valve marked “C” (Fig.6).
CONDENSING DRY To use dryer In Condensing Mode: 1. Ensure metal vent cap (1) is installed on exhaust fan. 2. Press "Dry Only" button to set the machine on drying cycle. 3. Hold venting/condensing button for 5 seconds 4, symbol will appear on the screen which confirms that the machine is in condensing mode. 5. Press start fo run dryer in condensing mode Condensing dry uses cold water to dry the clothes. The cold water mixes with the hot air in a condensing chamber within the machine.
WARNINGS DUE TO RISK OF FIRE USE ONLY METALLIC DUCT (RIGID OR FLEXIBLE). Never use flexible duct inside the dryer. Do not terminate exhaust in a chimney, range hood, gas vent, floor or attic. The combination of lint and grease could create a fire hazard or damages. Provide an access for inspection and cleaning the exhaust system at least once a year. EXHAUST SYSTEM CHECK LIST HOOD OR WALL CAP Terminate in a manner to prevent back drain or entry of birds or other wildlife.
VRl The Combo Washer-Dryer may be installed in a built-in, recessed area, closet or alcove. The installation spacing is in inches and is the minimum acceptable. Other installations must use the minimum dimension indicated. Minimum clearances between dryer cabinet and adjacent walls either side and 3" front and rear.| Minimum vertical space from floor to overhead cabinets, etc. is 52" (132cm). Closet door must be louvered or otherwise ventilated and must contain a minimum open area equally distributed.
PROGRAM SELECTION CHART 1. WASH & DRY, WASH ONLY, DRY ONLY it Wash features Program :)asdcnptmn o Water temp/Spin rpm/ Drying heat oa Duration & approx time Thick cottons Max heat 1300W (towels, jeans) Hot / 1200 / 1.23 hours 120 minutes Mixed cottons Max heat 1300W heavy (tapirs, Jonas) hours | Mex heat Max heat 1300W 3-STANDARD Mixed cations Warm / 1200/ 55 minutes | & n02.1 Cotton blends, light .
OPERATING IN CATIONS 1. Ensure the Combo Washer-Dryer is muted off. (Power Indicator light should be off}. Separate clothes by type, color and degrees of soiling. 3. For small items such as socks, children’s garments and small towels please use a Washing Net Bag. 4. Load clothes of the selected type loosely into the drum. If you are only washing clothes, you can fill the drum. If you are washing and then drying, please do not load clothes more than 2/3 full. 5. Close the Washer-Dryer door.
Control Panel Amorous WA!HER @ SENSOR DRYER Options Wash/Dry . A ash () Dir Dry Level TIME DRY 60 E e Wash only Delay Start "ol Drain only Bryon vent m Selectman [candling w Winterize OFF Loc Gl Buttons Introduction (1] Wash @ ary @ Wash Only @ Dry Only @ Color LED Display Venting Condensing selection bitten @ Delay Start(#} button To select Wash & Dry cycle together.
Display Panel Symbols Dry functions Time Dry Sensor Dry Door Unlocked / Locked Washing stages Chime On/Off Cycle countdown ) settings Delay start " <1 Temp HOT WARM COLD< Water temp Dry cycle Number of rinses Dry time/Remaining time Venting Mode Condensing mode. How to Run a Wash Cycle and Dry Cycle A 1. Press Wash+Dry button to power the machine on, the cycle will go to STANDARD and the indicator (sensor dry) will be on. 2. Press the Start button to run the STANDARD wash cycle and sensor dry cycle.
Add-a-sock Feature The wash program can be stopped at any time to add forgotten items to the laundry. Press PAUSE for 5 seconds. Door will open 2 mind after draining water so that it doss not overflow. Load clothes. Close door. Press START The cycle will continue from the point it stopped How to stop the wash cycle The wash program can be stopped at any time. Press pause for 5§ seconds Turn knob to OFF position To drain water tum knob to DRAIN ONLY on left side.
How to winterize for cold weather 1) Pour 2 cups of RV type Antifreeze in soap dispenser. 2) Select WINTERIZE cycle on knob and press START. Machine will Rinse & Spin. 3) Open coin trap once cycle is finished and drain out remaining water. 4) Shut off water at both faucets and disconnect water inlet hoses from faucets and drain LN (e Your Washer Dryer has been designed to operate with easy maintenance. Follow these simple maintenance procedures to obtain optimum performance: 1.
IN REMOVAL CHART Blood Rinse or soak fresh stain in cold water. Work detergent into any remaining stain. Rinse. If stain persists, put a few drops of ammonia on stain and repeat detergent treatment. Rinse. If necessary bleach. Numb Marks Rinse or soak in cold water. Work detergent into stain. Rinse. Bleach, if necessary. Stain may be impossible to remove Candle Wax Scrape off excess. Place stain between clean white blotters or several layers of facial tissues. Press with warm iron.
Ink Some ball-point inks are set by water. First test a scrap of cloth. Sponge stain repeatedly with acetone, acyl acetate or rubbing alcohol. Hair spray is effective. Launder. Bleach if necessary. Use acyl acetate on triathlete, male, anodyne and revel. Use acetone on other fabrics. NOTE: Some inks cannot be removed. Ketchup Scraps of excess. Soak in cold water 30 minutes. Pr-treat with a detergent paste. Launder. Mildew Brush off surface growth to keep mold spores from spreading.
TROUBLESHOOTING In most cases, when your washer-dryer fails to work, the problems arising can be easily solved without having to call for a technician. Before calling for assistance, always check these points.
TROUBLESHOOTING Not drying efficiently Is the end of the drain hose under water? Is the drain pump obstructed? Is the drum overloaded? Is the cold water faucet open? Is fabric softener being used? Condensation at soap dispenser Slight condensation can occur at soap dispenser and will evaporate.
DIAGNOSTIC MENU Code Description Component Part # E1 |Door not closed properly Door Switch 1108 E2 |Not Draining out water Drain Pump 1107 E3 |Not filling in with Water Cold water valve 1132 Hot water valve 1135 E4 |Overfilling Pressure Switch 1140 E5 |No Tumble/High Speed spin| Main motor 2201 Electronic Module 6638 E6 |No communication between| Communication 6639 Display board and EM Cable E8 |Not Drying properly Temp. sensor 6605-A of tub) E9 |Not Drying properly Temp.
