Super Combo ALL-IN-ONE COMBO WASHER + DRYER Model: 5500 QUESTIONS / SERVICE Phone/Text: 1-800-776-3538 Email: Service@ApplianceDesk.
Please read the Owner’s Manual carefully before using your ALL-IN-ONE COMBO WASHER + DRYER ................................................................. 1 Warranty .................................................................... 2 Technical Data .............................................................. 4 Important Safety Instructions.................................................. 5 Helpful Hints ................................................................ 6 Pre-installation ............
Congratulations on your new Super Combo! In addition to its contemporary design, this is a highly sophisticated engineered product that will give you many years of satisfaction. Here are some of the best reasons for buying your Super Combo The Washer + Dryer’s sleek and compact size design makes it a perfect appliance for any kitchen or laundry room. Washer + Dryer Specialized Wash Programs There are special wash programs for Sanitize, Allergen, Winterize etc.
WARRANTY INFORMATION Your appliance is protected by this warranty under normal, personal, family or household use for 1 Year Parts & Labor and limited commercial use (90 days) in USA and Canada.
EXCLUSIONS In no event shall Consolidated Brands be liable for incidental or consequential damages or for damages resulting from external causes such as abuse, operation misuse, neglect, alterations, normal wear and tear, incorrect voltage or acts of God. This warranty does not cover service calls which involve defective workmanship, damage due to other products while combined use with this product or materials covered by this warranty.
23.6 / 60 33.5 / 85 24 / 61 41.3 / 105 3 Inlet and Drain Hose length 6 Feet Power cable length 6 Feet Note: All rights reserved. Designs, Specifications and Manual subject to change without notice.
Your Combo Washer + Dryer has been built in compliance with safety regulation to protect you and your family. 16. To reduce the risk of fire due to contaminated loads, the final part of a tumble dryer cycle occurs without heat (cool down period). Avoid stopping a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.
MODEL No: SERIAL No: Washer + Dryer 1400 rpm 19 lbs. USE HIGH EFFICIENCY (HE) DETERGENT: By using High Efficiency (HE) detergent, Front Loading detergents The unit must be installed on a strong leveled surface in a protected, dry and well-ventilated area, with a power and water supply of sufficient capacity and a sufficient outlet in close proximity.
+ Detergent Dispenser Drawer Top Panel Control Panel Drum Venting Fan and Cover Hot Water Inlet Valve Door Cold Water Inlet Valve Leveling Feet Tube Cap Drain Hose Drain Tube Shipping Bolts U-Connector Power Cord Pump Filter Door Release Lever Water Inlet Hoses U-Connector Blanking Caps - 3 (For drain hose) (To cover shipping bolts hole) 7 Vent Adapter (To connect vent hose to exhaust fan)
Installation area Handling Please handle the machine carefully and use appropriate means while lifting and moving the machine so that it does not get damaged. Do not drag the machine on your floor. Do not hold on to protruding parts when lifting. Appliance stability is very important otherwise washing machine could “wander” during the spin cycles. Disposing of the packing The installation area must be solid and even. Soft floor surfaces such as carpets or surfaces with foam backing are not suitable.
Washer + Dryer Washer + Dryer Washer + Dryer bolts bolts bolts Retainer(3) P Clamp(1) Bush(3) Shipping bolt Retainer Washer(3) Shipping bolts(3) Lower Raise Lock nut Tighten all 4 locknuts securely NOTE · · · Save the bolt assemblies for future use. To prevent damage to internal components, DO NOT transport the washer-dryer combo without reinstalling the shipping bolts.
110V/60Hz Washer + Dryer 10 15
Dryer can be used in Ventless or Vented mode Icon for Ventless Icon for Vented VENTLESS (CONDENSING) DRY Use dryer in Ventless Mode: 1. ENSURE METAL VENT COVER (1) IS INSTALLED OVER EXHAUST FAN AS SHOWN IN FIG.8 2. Power on the machine 3. Press "Dry Only" button to set the machine on drying cycle. 4. Hold Vented/Ventless button for 5 seconds 5. symbol will appear on the screen which confirms that the machine is in Ventless mode. 6. Press START to run dryer in Ventless mode.
1. Unscrew the adapter ring plate and the 4 adapter retaining screws. Ring plate Guide plate 2. Remove the guide plate if the tap is too large to fit the adapter. 3. Push the adapter onto the end of the tap so that the rubber seal forms a watertight connection. Tighten the adapter ring plate and the 4 screws. Latch plate 4. Pull the connector latch plate down, push the inlet hose onto the adapter, and release the connector latch plate. Make sure the adapter locks into place.
MAXIMUM LENGTH OF THE VENT HOSE IS 10 FEET WITH THE 0.5 AMPS ORIGINAL EXHAUST FAN. USING LONGER VENT HOSE MAY DAMAGE INTERNAL COMPONENTS. FOR LONGER VENT HOSE USE 1.5 AMPS EXHAUST FAN, WHICH IS AVAILABLE AS AN ACCESSORY. 12" 4" 3 feet (1 meter) 3 feet (1 meter) For each 90o turn, deduct 33 feet (10 meters) from maximum length.
MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALATION Minimum clearances to combustible surfaces: 2" (5 cm) clearance both sides and 3" (7.5 cm) rear. BUILT-IN, RECESSED, CLOSET AND ALCOVE INSTALLATION The Combo Washer-Dryer may be installed in a built-in, recessed area, closet or alcove. The installation spacing is in inches and is the minimum acceptable. Other installation must use the minimum dimension indicated.
1. WASH & DRY, WASH ONLY, DRY ONLY Wash Programs Description of Load Wash Features Water Temp/Spin rpm/Duration Drying Heat & Approx Time Warm / 1200 / 51 mins Max heat - 1300W 90 mins Cold+Hot / 1400 / 75 mins Max heat - 1300W 120 mins (Towels, Jeans etc) Hot / 1400 / 61 mins Max heat - 1300W 120 mins Cottons Blends Cold / 800 / 31 mins Max heat - 1300W 80 mins 5. Quick 20 Light fabrics Cold / 1200 / 20 mins Max heat - 1300W 80 mins 6.
Washer + Dryer For small items such as socks, children’s garments and small towels please use a Washing Net Bag. If you are using Wash Only cycle, you can fill the drum. If you are using Wash + Dry cycle, please do not load clothes more than 2/3 full. Washer + Dryer Use Front Load detergent, as per direction. You can add fabric softener in Dispenser B & pre-wash detergent and bleach in Dispenser C (Fig.12) and bleach Fig.
NORMAL Self-Clean PAUSE 5s Add-a-sock 3s Extra Rinse 2s Child Lock 3s Drain 2s . For extra rinse, press and hold 1 + 2 together. Vented / Ventless selection button Ventless Vented Ventless mode. Ventless dry mode mode Vented dry mode. Press this button to select the dry level for a Sensor Dry cycle. The default is Normal and you can select Extra, Low or Damp Dry. Pause stop Dry only and Dry level buttons for 5 seccods Power Press this button to turn the machine on.
level options * Only for wash settings Ventless Mode * An extra rinse can be addedd (Condensing) A. How to run WASH + DRY Cycle by pressing “Wash+Dry” and “Wash Only” at the same time. An Extra rinse and 9 minutes will be added to the cycle. 1. Press POWER button 2. Press START Default cycle is NORMAL - If required you can change to desired washing cycle based on type of clothes by rotating the Program Dial knob. B. How to run WASH Only Cycle 1. Press POWER button 2. Press WASH Only button 3.
Add-a-sock Feature Press START/PAUSE for 5 seconds. How to stop the wash cycle - The wash program can be stopped at any time. - Press START/PAUSE for 5 seconds - Press POWER button for 3 seconds to turn off the machine How to stop the dry cycle - Press POWER button for 3 seconds to turn off the machine How to turn on the display in energy saving mode? - Machine display gets turned off automatically during operations to save energy.
(Fig.13) (Fig.14) (Fig.15) is (Fig.16) 2 1 Fig.13 Fig.14 Fig.15 Fig.16 (Fig.17) (Fig.18, Fig.19) Fig.17 Fig.18 Fig.19 - If Vent Dry mode is used, clean the exhaust fan and exhaust duct at least once a year to prevent lint build-up.
21
Brush off surface growth to keep mold spores form spreading. Dip article into solution of 1/2 cup bleach per 1 gallon (~3.8 Litres) of cool sudsy water for 5 to 10 minutes. Rinse well. Launder. 2 cups of water.
Washer + Dryer P E D S Power Hose correctly connected to the faucet? Water supply turned on? Sufficient Faucet filter clean? Inlet hose kinked? 4" Does selected program incorporate water draining? Drain pump clogged? Drain hose kinked? Coin trap clean? Front Load detergent Front loading bolts Machine levelled correctly? enough Not drying Is the dryer button correctly pressed for the drying cycle? Is drying cycle selected (Time Dry/Sensor Dry)? Condensation at soap dispenser Slight condensation can o
DIAGNOSTIC MENU DIAGNOSTIC MENU Code Description Component E1 Door open Door Switch E2 Drain failure Drain Pump E3 Water inlet failure Inlet Valves E4 Water overfill Pressure Switch E5 Motor failure Motor +Electronic Module E7 Washing heater failure Washing heater E8 Dryer Malfunction Temp. sensor (@rear-bottom of tub) E9 Dryer Malfunction Temp. sensor (@front of heater housing) E10 Water level failure Water level sensor E11 Dryer Malfunction Temp.