User guide

Equator Room Analysis User Guide v2.0

Setting Up Continued

Configure ID Switches

Speaker ID

ID switches 1, 2, 3, & 4 correspond to the speaker position within the room and will be

reflected as such within the Equator software. Use the legend on the back of each monitor

to determine ID positions based upon speaker placement (Front Left, Front Center, etc…)

Within the Legend:

1 = UP

0 = DOWN

In a stereo setup, the front left speaker ID switch (No. 1) is set in an upward position and

switches 2, 3, & 4 are in the down position. The right speaker ID switches (No. 1 & 2) are

both set in an upward position and switches 3 & 4 are in the down position.

System Groups

ID Switches 5 & 6 determines the System Group. These two switches allow up to four

separate groups of monitors to be networked together and called up independently within

Equator software. Each of these groups can be configured from stereo all the way up to 8.2.

In the stereo setup example (above image), switches 5 & 6 are set to the down position (0

0) which reflects System Group 1 as shown on the legend above.

Reserved

ID Switch No. 7 is reserved. It should always be set to the down position.

Room Correction

ID Switch No. 8 in the active up position allows communication between each Q Series

monitor and the Equator software.