User guide

Equator Room Analysis User Guide v2.0

Setting Up Continued

The Q8 and Q10 models have a universal power transformer which allows them to be used

at either 100-120v or 200-240v. The Q12, Q15, and Q18 are set internally at the factory

for use with 100-120v or 200-240v and are labeled as such on the back panel of the

amplifier for reference. Do not attempt to change these settings or the factory warranty will

be void.

Connect AC Power Cable

Connect each monitor to a power source using supplied AC power cable. DO NOT POWER

ON MONITOR YET

OS Compatibility (for use with Equator Control Software & Equator Room Analysis)

Mac OS X 10.4 or higher

Windows XP

Connect USB Cable

Create a USB connection between a computer and the USB port on the back of any Q

monitor.

DO NOT POWER ON MONITOR YET

Connect CAT5 Network Cable(s)

Plug a CAT5 network cable into the THRU port on the Q monitor that is connected to the

computer via USB and plug the other end of the CAT5 cable into the IN port on the next Q

monitor within the system. If there are additional Q monitors within the system, “Daisy-

Chain” from monitor to monitor from THRU to IN.