User`s manual

DemoKit-LG2 User’s Manual
8.
Click Finish to complete the installation of the driver.
Figure 38. USB Serial Port2 Driver Installation Completion (Windows XP)
5.3 Confirmation of USB Driver Installation
After installing the two types of drivers, which are needed for using the DemoKit-LG2 board with FPL3
GUI, you can verify that they were installed successfully by checking the Device Manager directory.
Figure 39. Device Manager Directory
 For Windows 98SE/Me: Do not execute Update and Erase commands when communicating with
the target device.
 For Windows 200/XP: Do not execute a Hardware Modification Scan when communicating with
the target device.
 In the GUI port list, select the same communication port as COM? of the USB serial port.
 If the drivers highlighted in Figure 39 are not displayed, or the mark "×" or "!" is prefixed, refer to
Section 10, “Troubleshooting.”
5.4 Driver Uninstallation
The driver uninstallation program is installed on the host computer when the FPL3 software is installed.
Use the procedure below for uninstalling the USB driver.
37