User's Guide
Table Of Contents
- 01 /
- Introduction
- 1.0/ Package Contents
- 1.1/ System Requirements
- 1.2/ Features
- 1.3/ Getting to Know Your Fios Home Wi-Fi Extender
- 02 /
- CONNECTING YOUR Fios Home Wi-Fi Extender
- 2.0/ Setting up Your Fios Home Wi-Fi Extender
- 2.1/ Main Screen
- 03 /
- WIRELESS SETTINGS
- 3.0/ Overview
- 3.1/ Wireless Status
- 3.2/ Basic Settings
- 3.3/ Advanced Settings
- 3.4/ Channel Settings
- 3.5/ Guest Network
- 04 /
- CONFIGURING ADVANCED SETTINGS
- 4.0/ Using Advanced Settings
- 4.1/ Management
- 4.2/ Admin Password
- 4.3/ Factory Default
- 4.4/ System Log
- 4.5/ Advanced Log
- 4.6/ DHCP Log
- 4.7/ BHM Log
- 05 /
- TROUBLE
- SHOOTING
- 5.0/ Troubleshooting Tips
- 5.1/ Frequently Asked Questions
- 06 /
- SPECIFICATIONS
- 6.0/ General Specifications
- 6.1/ LED Indicators
- 6.2/ Environmental Parameters
- 7 /
- NOTICES
- 7.0/ Regulatory Compliance Notices
54
/ TROUBLESHOOTING
verizonwireless.com | ©2019 Verizon Wireless. All Rights Reserved.
5.0d/ RESTORING YOUR FIOS HOME WIFI EXTENDER’S
DEFAULT SETTINGS
There are two ways to restore your Fios Home Wi-Fi Extender’s
default settings. It is important to note that after performing
either procedure, all previously saved settings on your
Fios Home Wi-Fi Extender will be lost.
• Using the tip of a ballpoint pen or pencil, press and hold the
Reset button on the back of your Fios Home Wi-Fi Extender for
three seconds.
• Access the GUI and navigate to the Advanced Settings page.
Select Factory Default option. Click the Restore Default Settings
button. For additional details, refer to the section 4.3/ Factory
Default section of this guide.
Note: If you reset or reboot your Fios Home Wi-Fi Extender, you
may also need to disconnect your Fios Home Wi-Fi Extender’s
power supply for a few minutes (3 or more) and then reconnect the
power cable. However, in order to provide full synchronization to the
coxial network, disconnecting and reconnecting the power may be
required.