Operation Guide
Table Of Contents
- Copyright Information
- Disclaimer
- Contents
- Diagram Index
- Table Index
- Notice
- User Service
- 1 Introduction
- 2 Interface and Component
- 3 Functions and Operation Instruction
- 3.1 Startup & Shutdown Button
- 3.2 Left and Right Buttons
- 3.3 Up and Down Buttons
- 3.4 Data Transmitting-receiving Indicator Light
- 3.5 3G/4G and Bluetooth Operating Condition
- 3.6 Instruction of Radio Startup and Power Indicator Light Conditions
- 3.7 Device Menu
- 3.7.1 Device Information
- 3.7.1 Device Information
- 3.7.2 Transmitting/Receiving Channel and Frequency
- 3.7.3 Data Protocol
- 3.7.4 RF Baud Rate
- 3.7.5 Transmitting/Receiving Mode
- 3.7.6 Transmitting Power
- 3.7.7 Serial Port Baud Rate
- 3.7.8 Serial Port Baud Rate Self-adaption
- 3.7.9 OLED Sleep Mode
- 3.7.10 Interference Detection
- 3.7.11 Language
- 3.7.11 Language
- 3.8 Use of Radio Configuration Software
- 3.9 Firmware Upgrade
- Appendix A Technical Indexes
- Appendix B Command
- Appendix C eRadio SIM Setup
- Appendix C eRadio SIM Setup
- Appendix D eRadio FAQ
2 Interface and Component
2.1 Interface of Serial Port Data Cable
The interface of serial port data cable uses the asynchronous serial
communication RS232 standard.
Figure 2 Diagram of eRadio Data Interface
Table 33 eRadio Data Interface Definition
Pin Name Description Remarks
1 VCC Power output DC9-16V
2 GND1
Power Ground
3 RXD
Serial port data
receiving
RS232 Level
4 GND2 Signal Ground
5 TXD
Serial port data
transmitting
RS232 Level
2.2 Radio Frequency Interface
The eRadio radio frequency interface uses 50 OHM TNC negative connector.
2.3 Instruction of Indicator Lights
3G/4G/BT is 3G/4G and Bluetooth red and green indicator light, red
indicator light represents 3G/4G module and green one represents
Bluetooth module;
RX/TX is data transmitting-receiving red and green indicator light, green
indicator light represents data receiving, red indicator light represents data
transmitting;
PWR/ALM is bi-color indicator light for normal power supply and
under-voltage, green indicator light represents normal power supply, red
indicator light represents abnormal voltage;